Quick start

After you've unpacked your Pearl Nexus, you're ready to get started. This quick start uses the default settings where possible so you can quickly start using your Pearl Nexus.

Before you begin, make sure you have:

• A video source such as a camera or computer and cables to connect them to Pearl Nexus. For HDMI, the video source must not be HDCP protected.

• An audio source coming from either your SDI or HDMI video source (must not be encrypted). Optionally, audio from a different source such as an audio mixer that you connect to the audio input ports can be used.

• The Pearl Nexus can use USB for video input.

• Local area network that uses Dynamic Host Configuration Protocol (DHCP) is preferable.

• Computer with a web browser connected to the same network. We'll call it the “admin” computer.

• Ethernet cables to connect Pearl Nexus and the admin computer to the network.

Your Pearl Nexus comes shipped with an AC/DC power adapter and a registration card that contains brief instructions to connect the Pearl Nexus to the network, log in to the Admin panel. The instructions in this quick start provide more details. Pearl Nexus ships with storage preinstalled (SD card or SSD, depending on model), so no separate storage setup is required before recording.

Start up the Pearl Nexus for the first time

• Turn on your camera or video source and connect the output to the back panel of Pearl Nexus.

• Connect the Ethernet cable to the Pearl Nexus and to your network.

• Attach the power cable and plug it into a power source.

• Turn on the system:

• Pearl Nexus - power button is on the back of the unit. Wait for the power-up cycle to complete. The RED and BLUE LEDs on the front of the unit flash during bootup. When bootup is complete, the RED and BLUE LEDs stop flashing and the WHITE power LED on the front of the unit is solid. If this is the first time Pearl Nexus is being turned on, the default configuration was just applied, or the unit was factory reset, the HDMI output displays system information — such as the IP address and Edge pairing code — on a connected display (customer-supplied).

• (Optional) Plug headphones into the 3.5 mm headphone jack at the front of the Pearl Nexus to monitor the video signal's embedded audio.

• (Optional) Start recording using the Admin panel.